PREVENTIVE MAINTENANCE CHECKS
AND SERVICES (PMCS) INTRODUCTION - CONTINUED
GENERAL PMCS PROCEDURES - CONTINUED
Notify Unit Maintenance of any leaks the operator cannot fix.
Leakage Definitions for PMCS
Leakage indicated by wetness or discoloration, but not great enough to form
Leakage great enough to form drops, but not enough to cause drops to drip from
the item being checked/inspected.
Leakage great enough to form drops that fall from the item being checked/
GENERAL LUBRICATION PROCEDURES
Lubrication instructions contained in this PMCS are mandatory.
Overall views of lubrications points are located at the end of this work package. Localized views are located,
together with specific lubrication instructions, in PMCS Table 1 (WP 0014 00)
This equipment is not covered by AOAP. Follow manufacturers hand-time maintenance intervals as specified
in this manual.
Refer to FM 9-207 for lubrication in arctic operation.
Included in this PMCS are lubrication services to be performed by the operator.
Lubrication intervals are based on normal operation. Lubricate more during constant use and less during inactive periods.
Use correct grade of lubricant for seasonal temperature expected (Refer to KEY on page 0013 00-4).
For equipment under manufacturer's warranty, hardtime intervals shall be followed. Shorten intervals if lubricants are
known to be contaminated or if operation is under adverse conditions (e.g., longer than usual operating hours, extended
idling periods, extreme dust, etc.).
Keep all lubricants in a closed container and store in a clean, dry place away from extreme heat. Keep container covers
clean and do not allow dust, dirt or other foreign material to mix with lubricants. Keep lubrication equipment clean and
ready for use.
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic material.
However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in well-ventilated
areas. Keep away from open flames and other sources of ignition. Failure to do so may result in injury or
death to personnel.
Clean area around lubrication points with dry cleaning solvent (Item 3, WP 0026 00) or equivalent before lubricating
equipment. Keep all external parts of equipment not requiring lubrication free of lubricants. After lubrication, wipe off
excess lubricant to prevent accumulation of foreign matter.
Maintain a record of lubrication performed and report any problems noted during lubrication. Refer to DA Pam 738-750
for forms and procedures to record and report any findings.