AIRDROP BY C-130 AIRCRAFT - CONTINUED
CONFIGURE MACHINE FOR AIRDROP - CONTINUED
Remove taillights and stow on side of BII toolbox:
Remove three bolts, washers and back panel from taillight.
Disconnect three connectors.
Remove bolt, washer and disconnect ground wire.
Remove two bolts, washers and taillight from top of fuel tank. Reinstall washers and bolts.
Install taillight on side of BII toolbox using two bolts and washers on side of BII toolbox.
Install back panel, three washers and bolts on taillight.
Repeat for other taillight.
AND BACK PANEL
AND GROUND WIRE
Remove fuel neck and stow on side of BII toolbox:
DO NOT perform fuel system maintenance while smoking or near fire, flames or sparks. Fuel may ignite,
causing injury or death to personnel or damage to machine.
Remove four bolts, washers and fuel neck from top of fuel tank.
Inspect seal and replace if damaged.
Remove four bolts, washers and cover from side of BII toolbox.
Install cover, four washers and bolts on top of fuel tank.
Install fuel neck, four washers and bolts on side of BII toolbox.