TM 5-3800-205-23-1
TROUBLESHOOTING PROCEDURES - CONTINUED
0007 00
Table 11. Water Distributor Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
5. No Pressure Discharge From Right Upper
b. If problem still exists after
adjustment,
notify
DS
Spray Bar - Continued.
Maintenance to replace main
control valve.
6. Pump Control Lever (Elevator Control Lever)
1. Check for bent or damaged
a. If lever is bent or damaged,
Binds.
lever.
b. If lever is okay, go to test step
2.
2. Check elevator valve, inboard
a. Clean debris from control
of left fender, for buildup of
valve linkage.
debris.
b. If problem still exists, go to
test step 3.
a. Adjust relief valve setting.
3. Perform Main Control Valve
b. If problem still exists after
adjustment,
notify
DS
Maintenance to replace main
control valve.
7. Pump Control Lever (Elevator Control Lever)
Check for bent or damaged
Replace bent or damaged
Will Not Engage.
linkage.
8. Pump Control Lever (Elevator Control Lever)
Check for bent or damaged
Replace bent or damaged
Will Not Return to Hold Position.
linkage.
9. Tank Cannot Be Filled Using Pressurized
1. Check that TANK FILL
If switch is ON and problem still
Water Source Through Suction Inlet.
SPARGER switch is ON.
exists, notify DS Maintenance to
replace pump.
a. Adjust relief valve setting
2. Perform Main Control Valve
b. If problem still exists after
adjustment,
notify
DS
Maintenance to replace main
control valve.
If control lever is in FORWARD
10.Tank Cannot Be Suction Loaded Using
1. Check that locking lever
position and problem still exists,
Onboard Pump.
(elevator direction control
lever) is in FORWARD
5-3800-205-23-3).
position.