TM 5-3800-205-23-1
ETHER COLD START AID SYSTEM MAINTENANCE - CONTINUED
0022 00
CLAMP AND SOLENOID VALVE INSTALLATION
1.
Install solenoid valve (4) and clip (15) on left fender bracket (9) with four washers (18), two screws (17), and nuts (16).
2.
Install elbow (11) on solenoid valve (4).
3.
Install tube (13) and fitting (12) on elbow (11).
4.
Connect solenoid valve connector (14) to wiring harness connector (19) and install in clip (15).
5.
Install retaining clamp (2) on left fender bracket (9) with four washers (18), two screws (17), and nuts (16).
6.
Remove protective cap (10) from solenoid valve (4).
7.
Install ether cylinder (refer to Ether Cylinder Replacement).
ETHER ATOMIZER REPLACEMENT
1.
At top of engine, remove fitting (20) and tube (13)
13
from atomizer (21).
20
2.
Remove atomizer (21) from adapter (22).
21
3.
Remove adapter (22) and O-ring (23) from engine.
22,23
Discard O-ring.
4.
Install new O-ring (23) and adapter (22) on engine.
NOTE
Position atomizer so that direction of spray
is parallel to air inlet heater.
5.
Install atomizer (21) on adapter (22).
6.
Install tube (13) and fitting (20) on atomizer (21).
END OF WORK PACKAGE
0022 00-3