TM 5-3800-205-23-1
SEAT REPAIR - CONTINUED
0104 00
ASSEMBLY - CONTINUED
NOTE
Install new tiedown straps to secure wiring harness and air tubes to seat suspension.
One plastic retainer at rear of seat suspension is installed with head at INSIDE of upper plate.
34.
Position boot (19) around seat suspension and secure with 32 plastic retainers (18) and one nut (20). Extend seat wiring
harness out through rear of seat suspension and boot.
35.
While positioning front two guides (15) and rear two guides (15) into notches of seat suspension, slide seat adjuster (10)
over all four guides until centered on seat suspension.
36.
Position stop block (17) to right-front corner of seat adjuster (10) and secure with two bolts (16).
37.
Position seat adjuster (10) so that two setscrews (14) can be seen through two holes at left side of seat adjuster. Tighten
each setscrew approximately two turns. Check that seat adjuster can freely move forward and back when lever is oper-
ated, but without excess slack. Adjust setscrews as necessary.
14
10
15
20
19
16
18
17
0104 00-28