TM 5-3800-205-23-1
STEERING HYDRAULIC CONTROL VALVE REPLACEMENT - CONTINUED
0154 00
INSTALLATION - CONTINUED
NOTE
10
13
14
Lubricate all new O-rings with clean oil
prior to installation.
3.
Position tube (13) on steering control valve (10) and
install flange (16) and new O-ring (17) with four
washers and bolts (15).
4.
Repeat step 3 to install tube (14) on steering control
valve (10).
16,17
15
5.
Position tube (9) on steering control valve (10) and
3,4
2
5
1
6
7,8
install flange (7) and new o-ring (8) with four washers
and bolts (6).
6.
Position hose (3) and new O-ring (4) on steering con-
trol valve (10) and tighten retaining nut (5).
7.
Install yoke rod end (1) on steering control valve (10)
with bolt (2), nut (12), and new cotter pin (11).
9
12
11
10
8.
WARNING
If machine is parked indoors, DO NOT run engine unless exhaust fumes are vented to the outside. Failure to
follow this warning may cause injury or death due to carbon monoxide poisoning.
9.
Operate steering system and check for leaks.
END OF WORK PACKAGE
0154 00-5