TM 5-3805-248-23-1
TRANSMISSION TROUBLESHOOTING PROCEDURES - CONTINUED
0013 00
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
NOTE
6.
Machine Moves in Neutral.
Differential and transmission oil level, leaking lines or components, missing
detents and physical damage to linkages should all be corrected prior to per-
forming any diagnostics.
Check control linkage for improper
1. If control linkage is not adjusted
properly, or is damaged or defective,
2. If problem still exists, replace
transmission (WP 0286 00).
NOTE
7.
Transmission Is
Inoperative in One or
Differential and transmission oil level, leaking lines or components, missing
More Speed(s).
detents and physical damage to linkages should all be corrected prior to per-
forming any diagnostics.
1.
Check shift control cable for damage
1. Adjust or replace linkage as necessary.
2. If problem still exists, replace
transmission (WP 0286 00).
NOTE
8.
Transmission Stays in a
Differential and transmission oil level, leaking lines or components, missing
Previous Gear.
detents and physical damage to linkages should all be corrected prior to per-
forming any diagnostics.
1.
Check shift points adjustment (WP
1. Adjust as necessary.
0285 00).
2. If problem still exists, go to Test 2.
2.
Check transmission hold. Refer to Air
2. If problem still exists, replace
transmission (WP 0286 00).
9.
Loss of Lubricant.
Check differential breather for leaks or
Replace differential breather, if necessary
WARNING
10. Continuous Axle of Wheel
Noise.
Chock wheels of machine to prevent rolling, shifting or slipping while raising
machine from ground. Failure to follow this procedure may cause injury.
1.
Replace wheel bearings, if necessary (WP
(WP 0302 00 and WP 0303 00).
0302 00 and WP 0303 00).
END OF WORK PACKAGE