TM 5-3805-248-23-1
BARRING ENGINE OVER - CONTINUED
0028 00
BARRING ENGINE OVER
1.
Remove timing bolt (5), washer (4) and clip from left
side of flywheel housing. Leave clip attached to har-
ness.
2.
Remove bolt (6), washer (7), cover (3) and gasket (2).
Discard gasket.
3.
Remove plug (1).
CLIP
1
7
6
2
5
3
4
394-483
4.
Install engine turning tool through left side of flywheel housing until shoulder of engine turning tool is against flywheel
housing. Engine pinion turning tool engages ring gear on flywheel housing.
5.
Insert 1/2 in. (13 mm) ratchet in engine turning tool.
NOTE
When direction of engine rotation is specified, engine is viewed from rear.
6.
Rotate 1/2 in. ratchet counterclockwise on engine.
7.
Install plug (1) in flywheel housing.
8.
Position new gasket (2) and cover (3) on flywheel housing.
9.
Install washer (7) and bolt (6).
10.
Install clip, washer (4) and timing bolt (5)
END OF WORK PACKAGE
0028 00-2