SECONDARY FUEL FILTER AND BASE REPLACEMENT - CONTINUED
FILTER ELEMENT REMOVAL - CONTINUED
Use a container to capture draining fuel. Dispose of fuel IAW local policy and ordinances. Ensure all spills
are cleaned up.
Remove and discard secondary fuel filter (1).
FILTER ELEMENT INSTALLATION
Lubricate new filter seal with clean diesel fuel.
Do not overtighten new filter. Failure to follow this procedure may cause equipment damage.
Install new secondary fuel filter (1) by hand. Rotate clockwise until seal contacts base, then rotate one additional full
turn to seal.
Place battery disconnect switch in ON position (TM 5-3805-248-10).
Start engine (TM 5-3805-248-10). Remain in cab with engine running. Have assistant check for leaks between second-
ary fuel filter and base.
Shut down engine (TM 5-3805-248-10).