TM 5-3805-248-23-1
CUTTING EDGE WORKLIGHT REPLACEMENT - CONTINUED
0086 00
CUTTING EDGE WORKLIGHT ASSEMBLY REMOVAL
1.
Remove screw (5) from rear of worklight housing (3).
2.
Disconnect connector (6).
3.
If necessary, remove cutting edge worklight lamp, refer to Cutting Edge Worklight Lamp Removal in this work package.
4.
If necessary, remove screw (10) and lug terminal (2).
5.
If necessary, remove lens retainer (1) from worklight housing (3).
6.
Remove nut (8), lockwasher (9) and washer (7). Discard lockwasher.
7.
Remove worklight housing (3).
8.
Remove washer (4) from worklight housing (3).
CUTTING EDGE WORKLIGHT ASSEMBLY INSTALLATION
1.
Install washer (4) on worklight housing (3).
2.
Install worklight (3).
3.
Install washer (7), new lockwasher (8) and nut (9).
4.
If removed, install lens retainer (1) on worklight housing (3).
5.
If removed, position terminal lug (2) on lens retainer (1).
6.
If removed, install screw (10) in terminal lug (2).
7.
If removed, install cutting edge worklight lamp. Refer to Cutting Edge Worklight Lamp Installation in this work pack-
age.
8.
Connect wire connector (6).
9.
Install screw (5).
10.
Verify correct operation of worklight (TM 5-3805-248-10).
END OF WORK PACKAGE
0086 00-3/(-4 blank)