TM 5-3805-248-23-1
WATER TEMPERATURE SENDING UNIT REPLACEMENT - CONTINUED
0092 00
REMOVAL
1.
Remove nut (1) and washer (2) from top front of engine.
2.
Disconnect wire connector (3) at terminal.
3.
Remove water temperature sending unit (4).
1,2
3
4
INSTALLATION
CAUTION
Do not hit or drop temperature sender on any hard surface. Damage to sender may occur if dropped.
1.
Install water temperature sending unit (4).
2.
Connect wire connector (3) at terminal.
3.
Install washer (2) and nut (1).
4.
5.
6.
Operate engine and allow to reach normal operating temperature (TM 5-3805-248-10).
7.
Verify correct operation of temperature gage.
END OF WORK PACKAGE
0092 00-2