TM 5-3805-248-23-1
BACKUP ALARM SWITCH REPLACEMENT - CONTINUED
0101 00
REMOVAL
NOTE
Tag all wire connectors before disconnecting to ensure correct installation.
1.
Remove nut (2) and washer (1) from transmission range selector housing on right side of operator compartment.
2.
Lower backup alarm switch (8) assembly through bottom of transmission range selector housing.
3.
If necessary, remove bolt (9) and nut (10) from transmission range selector.
4.
Remove two screws (4) and lockwashers (5). Discard lockwashers.
5.
Disconnect two wire connectors (3) at terminals.
6.
Remove nut (7) and backup alarm switch (8) from bracket assembly (6).
TRANSMISSION RANGE
SELECTOR HOUSING
1
2
3
4,5
6
10
394-224
7
9
8
INSTALLATION
1.
Install backup alarm switch (8) in bracket assembly (6).
2.
Install nut (7).
3.
Connect two wire connectors (3) at terminals.
4.
5.
Position backup alarm switch (8) assembly into transmission range selector housing.
6.
If removed, install nut (10) and bolt (9).
7.
Install washer (1) and nut (2).
8.
Adjust bolt (9) so that switch (8) is pressed only when transmission range selector is placed in REVERSE.
9.
Operate machine and verify backup alarm sounds when transmission range selector is placed in REVERSE (TM 5-
3805-248-10).
END OF WORK PACKAGE
0101 00-2