MAGNETIC STRAINER REPLACEMENT - CONTINUED
CLEANING AND INSPECTION
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear eye protection
Remove preformed packing material from mounting surfaces.
Clean all parts with solvent.
Dry all parts with compressed air.
Inspect all parts for damage and replace as necessary.
Install magnet (8) on tube assembly (7).
Install tube assembly (7) in filter element (9).
Install filter element as an assembly into pump housing.
If removed, install washer (4) and two screws (5).
Lubricate all preformed packings with clean lubricating oil prior to installation.
Install new preformed packing (6) and cover (1).
Read sight gage and add transmission oil as necessary (TM 5-3805-248-10).
Operate machine (TM 5-3805-248-10) and check for transmission oil leaks.
END OF WORK PACKAGE
0130 00-3/(-4 blank)