TM 5-3805-248-23-1
ROLLOVER PROTECTION DOOR MAINTENANCE - CONTINUED
0202 00
ASSEMBLY - CONTINUED
10.
Install cover (23), three washers (25) and bolts (24) on door assembly (14).
11.
Install washer (27) and new cotter pin (26) on handle shaft.
12.
Install cover (22), three washers (21) and bolts (20) on door assembly (14).
NOTE
Do not put bulk seal on hinge side.
13.
Install seal (19) to inner lip of door assembly (14). Cut
18 (HIDDEN)
14
12
142 in. (361 cm) of bulk seal (19) to fit in five sections
19
around door assembly (14).
14.
Position hinge (12) on door assembly (14) and install
thirteen screws (18) on hinge (12).
20,21
22
23
24,25
26,27
394-362
INSTALLATION
1.
Attach lifting device to door assembly (14).
2.
Use lifting device to position door assembly (14) on
13
14
12
cab frame.
NOTE
Before tightening hinge bolts, align hinge
to marks made during removal.
3.
Position bracket (15), install eleven screws (13),
washers (17) and nuts (16) on hinge (12).
16,17
(HIDDEN)
15
394-361
4.
Close door assembly (14). Inspect alignment by making sure all sections of seal (19) are flush against cab frame.
0202 00-5