TM 5-3805-248-23-1
BOWL LIFTING CHECK VALVE ASSEMBLY REPLACEMENT - CONTINUED
0228 00
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
serious injury or death. Make sure air stream is directed away from user and other personnel in the area.
To prevent injury, user must wear protective goggles or face shield.
1.
Remove all preformed packing material from mounting surfaces.
2.
Clean all parts with solvent.
3.
Dry all parts with compressed air.
4.
Inspect all parts for damage and replace as necessary.
INSTALLATION
1.
Install two new preformed packings (3).
2.
Install bowl lifting check valve.
3.
Install two washers (2) and bolts (1).
4.
Install connector (20), new preformed packing (18) and elbow (17).
5.
Connect hose assembly (19).
6.
Install new preformed packing (24).
7.
Connect tube assembly (23).
8.
Install two flange halves (25), four washers (22) and bolts (21).
9.
Install new preformed packing (16).
10.
Connect hose assembly (15).
11.
Install two flange halves (26), four washers (14) and bolts (13).
12.
Install new preformed packing (12).
13.
Connect hose assembly (11).
14.
Install two flange halves (10), four washers (9) and bolts (8).
15.
Install connector (4), new preformed packing (6) and elbow (5).
16.
Connect hose assembly (7).
0228 00-3