TM 5-3805-248-23-1
HYDRAULIC CONTROL VALVE HOSES, LINES AND FITTINGS REPLACEMENT - CONTINUED
0232 00
INSTALLATION - CONTINUED
32.
Install new preformed packing (9) and connect hose assembly (1) to hose assembly (7).
33.
Install two flange halves (8), four washers (6) and capscrews (5) to hose assembly (1).
34.
Install clamp (4), washer (3), bolt (2), washers (11) and nut (10) to hose assembly (1).
35.
Install any straps, ties or guards noted during removal.
2,3
1
4
5,6
7
394-524
8,9
10,11
(HIDDEN)
36.
WARNING
Only a qualified operator may perform the following procedure. All other personnel must clear the immedi-
ate area of the vehicle. Failure to follow this warning may cause injury. If you are injured, obtain medical aid
immediately.
NOTE
If hose or tube assemblies were removed from a certain system, such as the ejector, operate only the ejector
control. If hose or tube assemblies were removed from all systems, operate all the controls to complete the
next procedure.
37.
Start engine (TM 5-3805-248-10).
38.
Operate hydraulic controls. Move each system through at least five full movements of travel to bleed the air out of sys-
tem (TM 5-3805-248-10).
39.
Stop engine (TM 5-3805-248-10).
40.
Refill hydraulic tank to correct level (TM 5-3805-248-10).
41.
Inspect hoses assemblies and connections for leaks (TM 5-3805-248-10).
END OF WORK PACKAGE
0232 00-11/(-12 blank)