CRANKSHAFT PULLEY AND DAMPER REPLACEMENT - CONTINUED
CLEANING AND INSPECTION
Solvent cleaning solvent MIL-PRF-680 Type III is an environmentally compliant and low toxic mate-
rial. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in well-
ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
serious injury or death. Make sure air stream is directed away from user and other personnel in the area.
To prevent injury, user must wear protective goggles or face shield.
Clean all parts with solvent.
Dry all parts with compressed air.
Inspect all parts for damage and replace as necessary.
Install damper (1).
Lubricate six washers (2) and bolts (3) with clean oil.
Install six washers (2) and bolts (3).
Install pulley (4).
Install four bolts (5).
Install radiator and support (WP 0044 00).
Operate engine and verify correct operation (TM 5-3805-248-10).
END OF WORK PACKAGE