TM 5-3805-248-23-2
ENGINE OIL COOLER REPLACEMENT - CONTINUED
0269 00
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
serious injury or death. Make sure air stream is directed away from user and other personnel in the area.
To prevent injury, user must wear protective goggles or face shield.
1.
Remove all gasket and preformed packing material from mounting surfaces.
2.
Clean all parts with solvent.
3.
Dry all parts with compressed air.
4.
Inspect all parts for damage and replace as necessary.
INSTALLATION
1.
Install new seal (20) and adapter (21) on core assembly (19).
2.
Install new preformed packing (22) and bonnet (23)
18
on adapter (21).
19
17
3.
Install new seal (18) and bonnet (17) on core assembly
20
(19).
21
4.
Install two hoses (25) on bonnet (17).
22
5.
Install two clamps (24).
6.
Loosely install four clamps (16) on two hoses (25).
23
7.
Attach lifting device to engine oil cooler assembly.
24
8.
Use lifting device to install engine oil cooler assembly.
9.
Tighten four clamps (16).
25
16
394-663
0269 00-4