CONTROL GROUP PRESSURE TEST - CONTINUED
CLEANING AND INSPECTION
Dry cleaning solvent MIL-PRF-680 Type III is an environmentally compliant and low toxic material.
However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in well-venti-
lated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear eye protection.
Remove all gasket material from mounting surfaces.
Clean all parts with solvent.
Dry parts with compressed air.
Visually inspect parts for damage. Replace damaged parts as necessary.
Remove transmission hydraulic test set from rear of vehicle.
Disconnect chain from yoke.