HYDRAULIC RETARDER MAINTENANCE - CONTINUED
REMOVAL - CONTINUED
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may cause injury or death.
Weight of retarder assembly is 210 lb (95
Install link bracket, 5/8-112B THD bolt and lifting
device on hydraulic retarder. Remove slack from lift-
Remove two nuts (8), washers (9), nine bolts (10) and
Install three 7/16-14NC forcing screws on cover (12).
Tighten three 7/16-14NC forcing screws gradually and
in succession, and separate hydraulic retarder assem-
bly from flywheel housing.