DIFFERENTIAL AND BEVEL GEAR ASSEMBLY REPLACEMENT - CONTINUED
CLEANING AND INSPECTION
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear eye protection.
Remove all preformed packing material from mounting surfaces.
Clean all parts with solvent.
Dry parts with compressed air.
Inspect all parts and replace if damaged.
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may cause injury or death.
Attach lifting device to differential and bevel gear assembly (5) and remove from wood blocks.
Install new preformed packings (3, 4, 6 and 7) on bevel gear assembly (5).
Install differential and bevel gear assembly (5) on transmission. Splines on transmission output shaft and internal splines
of differential assembly can be aligned by turning the large visible gear on the rear of the differential.