AIR DRYER REPAIR - CONTINUED
CLEANING AND INSPECTION
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear eye protection.
Remove all gasket material from mounting surfaces.
Clean all parts with solvent.
Dry all parts with compressed air.
Inspect all parts for damage and replace as necessary.
All parts furnished in kits are used during assembly.
Install washer (42) and new filter (41) on bolt (22),
with cloth side of filter (41) toward cartridge (30).
Insert bolt (22) into cartridge (30).
Pour entire package of new desiccant material into
Install new plate (43) on bolt (22), with cloth side of
plate (43) toward desiccant material.
Tap plate (43) with soft-face hammer to settle desic-
cant material into cartridge (30). Plate (43) must fit
into cartridge (30) below shoulder of bolt (22).
Install spring (6) and seat (44) on bolt (22).