SCRAPER WHEEL AND TIRE REPLACEMENT - CONTINUED
INSTALLATION - CONTINUED
Install bearing (9), retainer (7) and three bolts (5) equally spaced. Torque bolts to 50 lb-ft (68 Nm).
Thread one nut onto each forcing screw. Install two forcing screws and nuts equally spaced in retainer (7). Tighten two
forcing screws by hand until contact is made with end of rear axle housing. Tighten two nuts to hold two forcing screws
Remove three bolts (5) and retainer (7). Do not remove forcing screws from retainer.
Measure and record depth from end of each of forcing
screw to machined surface of retainer (7).