HEATER ASSEMBLY, MOTOR, BLOWER ASSEMBLIES AND CASE REPAIR - CONTINUED
CLEANING AND INSPECTION
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear protective goggles or face shield.
Clean all parts with solvent cleaning compound and dry with compressed air. Ensure that all seal material is removed
from mounting surfaces.
Inspect all parts for damage and replace as necessary.
Install grommets (51 and 39) on blower case (13).
Install plugs (40, 50, 52, 53 and 54) on blower case (13).
Install plate (47) on blower case (13) with four washers (48) and bolts (49).
Install new seal (45) and baffle (46) on blower case (13).
Install two washers (43) and bolts (44) on blower case (13).
Install washer (41) and bolt (42) on blower case (13).
Install harness assembly (10) on blower case (13).
Install motor assembly (8) on bracket (38) with new
seal (37) and strap (36).