CRANKSHAFT FRONT SEALS REPLACEMENT - CONTINUE
INSTALLATION - CONTINUED
Install locator assembly and three bolts on crankshaft
Use clean engine oil to lubricate outside lip of new
front seal wear sleeve (2) and lip of new crankshaft
front seal (1).
Position new crankshaft front seal (1) on locator
Install seal installer on locator assembly.
Slide pusher plate on stud of the locator assembly.
Install nut on stud and tighten until pusher plate is at bottom.
Remove nut, pusher plate, seal installer, three bolts and locator assembly.
Check engine oil level and add as necessary (WP 0022 00).
Operate engine and verify correct operation (TM 5-3805-248-10).
END OF WORK PACKAGE