CAMSHAFT MAINTENANCE - CONTINUED
REMOVAL - CONTINUED
Insert 1/2 in. ratchet in engine turning tool.
Position timing bolt (6) and locate against flywheel housing.
When direction of engine rotation is specified, engine is viewed from rear.
Rotate 1/2 in. ratchet on engine counterclockwise while holding timing bolt (6) in position. Stop turning when timing
bolt (6) can be threaded into hole in flywheel housing. Hand-tighten timing bolt (6).
If engine is turned past timing hole, rotate clockwise 30 degrees, then repeat step 7.
Pivot number one rocker arm (8) up and down on shaft
by hand. If number 1 rocker arm can be moved by
hand, engine is in position for camshaft removal (top,
center, number 1 piston compression stroke). Proceed
to step 10. If number 1 rocker arm cannot be moved by
hand, complete step 9.