FUEL INJECTION PUMP REPAIR - CONTINUED
ASSEMBLY/ADJUSTMENT - CONTINUED
Exercise care when tightening bushing. If it is too tight, the fuel injection pump housing will be damaged. If
not tight enough, leakage will result. Failure to follow this procedure could result in damage to equipment.
Use wrench to torque housing (8) to 30 lb-ft (41 Nm).
Install new felt washer (1), new preformed packing
(18) and fitting (19).
Remove bolt, timing plate, shaft, bolt and pointer assembly.
Use adapter to test assembled fuel injection pump on a fuel injection test bench. Refer to Test Bench instruction manual.
Operate machine and verify correct operation (TM 5-3805-248-10).
END OF WORK PACKAGE