GOVERNOR ASSEMBLY REPAIR - CONTINUED
FUEL SETTING PROCEDURE
The fuel setting procedure can be performed with the fuel injection pump and governor on or off the engine.
Remove plug (87) and cover (86) from fuel injection pump housing.
Install and zero fuel injection tool kit as follows:
a. Install collet (92) on bracket assembly (89).
Position indicator (91) arm in approximate middle of travel to ensure it engages in slot (93) in rack, and install
bracket assembly (89) on fuel injection pump housing.
Install ground body bolt (8) first and bolt (90) and ensure indicator (91) arm moves freely.
Put indicator (91) in position in collet (92).
The contact point will not go through collet and must be assembled after indicator stem has passed through
e. Assemble fuel injection tool kit contact point and extension and install on indicator (91).
Tighten collet (92) just enough to hold indicator (91).