AIR-FUEL RATIO CONTROL MAINTENANCE - CONTINUED
CHECK AND ADJUSTMENT OF FUEL RATIO CONTROL LINKAGE - CONTINUED
Needles of dial indicator will not follow turning of adjustment screw. It may be necessary to repeat steps 3
through 5 until adjustment is correct.
If an adjustment is necessary, use outer part (50) of rack adjusting tool to loosen locknut and then use hex wrench (52) to
turn adjusting screw. Turn screw out to make setting more positive, or in to make setting more negative. Ensure that
locknut is tight after adjustment. There is a zero tolerance for linkage setting if an adjustment is made.
Operate engine and verify correct operation (TM 5-3805-248-10).
Install hood (WP 0189 00).
Install side panel (WP 0191 00).
END OF WORK PACKAGE