PRESSURE AND SELECTOR VALVE ASSEMBLY REPLACEMENT - CONTINUED
Disconnect wire connector (1) from supplemental steering pump pressure switch at right-rear of machine.
Wipe area clean around all connections prior to removal. Cap hydraulic oil lines and plug openings after
removal. Contamination of hydraulic system could result in premature failure.
Remove supplemental steering pump switch and pre-
formed packing (2).
PUMP PRESSURE SWITCH
Use a container to capture draining
hydraulic oil. Dispose of hydraulic oil
IAW local policy and ordinances.
Ensure all spills are cleaned up.
Tag hose and tube assemblies prior to
removal to ensure correct installation.
Note routing of all hose assemblies
prior to removal to ensure correct
Remove seven bolts (3), washers (6), cover (4) and
gasket (5). Discard gasket.