TM 5-3805-248-23-2
TRANSMISSION PLANETARY REPAIR - CONTINUED
0373 00
CLEANING AND INSPECTION
WARNING
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may cause
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear protective goggles or face shield.
1.
Remove all preformed packing material from mounting surfaces.
2.
Clean all parts with solvent cleaning compound.
3.
Dry all parts with compressed air.
4.
Inspect all parts for damage and replace as necessary.
ASSEMBLY
1.
Install two dowels (209) in manifold (208).
2.
Install two seal rings (207).
3.
Install carrier (206) and pin (210).
4.
Install cage (205) into manifold (208).
5.
Install three locks (211) and six bolts (212). Bend ends of three locks upward against six bolts.
6.
Immerse bearing (204) in clean engine oil.
NOTE
Exercise care when installing any bearing without a sleeve. Drive only on the race adjacent to the mounting
surface.
7.
Use driver and hammer to install bearing (204).
8.
Immerse bearing (200) in clean engine oil.
9.
Note position of notch in bearing (200). Use driver and hammer to install bearing in retaining plate (201).
10.
Install retaining plate (201).
11.
Install retaining ring (199).
12.
Install hub (198), gear (197) and snap ring (196).
13.
Install three locks (202) and six bolts (203). Bend ends of three locks upward against six bolts.
0373 00-31