BOWL LIFT CYLINDER REPAIR - CONTINUED
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may cause injury or death.
Weight of bowl lift cylinder is 270 lb (122 kg).
Attach lifting device to bowl lift cylinder assembly.
Place cylinder assembly on cylinder repair stand with holes for hydraulic lines facing down.
Use care when placing support under rod. Rod must be protected against nicks and scratches. Failure to fol-
low this procedure could result in damage to equipment.
Place cylinder assembly on cylinder repair stand and
remove lifting device.
Extend rod (5) to its farthest length of travel and
secure or support.
Remove two bolts (4) and washers (3).
Remove six bolts (6) and washers (7).
Use hydraulic puller to remove head assembly (8)
from collar (1).
Use pump group to remove bearing (2) from collar (1).