TM 5-3805-260-10
(4)
Disconnect jumper hose from fittings on
right side of tractor near fender. Store in
tool box.
(5)
Connect the two larger hoses coming from
the load transfer valve to the fittings that
the jumper hose was removed from.
(6)
Install two jacks between the lugs on the
front frame and the lugs on the load
transfer axle. Start the engine. Using the
load transfer axle valve, lower the axle
cylinders until their eyes are close to the
lugs on the axle. Stop the engine. Using
the jacks to align the cylinder eyes with the
lugs, install the cylinder pins.
(7)
Start the engine. Raise the bowl about
one foot. Open the bowl floor about six
inches back from the closed position.
Place a hardwood block under the cutting
edge.
1-49