INSTALL SHUTOFF HOUSING
1. Put 5S1454 Sealing Compound on the outside
diameter of the seal and install the seal (I) with
tooling (A) in the shutoff housing with the lip toward
the outside. The outer face of the seal must be .039
in. (1.0 mm) below the surface of the housing.
Remove the extra sealing compound from the
housing and the seal after installation.
2. Install shaft (3) in the shutoff housing.
3. Install lever (5) on shaft (3).
4. Install shaft (2) in the shutoff housing.
5. Install lever (4) on shaft (3).
6. Put cover (6) in position on the shutoff housing and
install the two bolts that hold the cover to the
7. Install cover (8) on cover (6).
8. Install solenoid (7) on the cover.
9. Install cover (6) on the pump housing.
10. Install the gasket, flange assembly, gasket and
flange on the cover.