TM 5-3805-260-24
TIMING GEAR COVER AND OIL PUMP
8.
Loosen the clamp and disconnect hose (12) from
the timing gear cover.
9.
Remove water temperature sending unit (11) from
the timing gear cover.
10.
Remove the two bolts, connector (10) and the
gasket.
11.
Remove the two bolts that hold front support (14)
to the tractor frame.
12.
With tooling (B) lift the engine enough to take the
weight off of support (14).
13.
Remove four bolts (13) and support (14).
14.
Make a replacement of bolts (15) and (16) on the
top of the timing gear cover with two 7/16" x 14
NC forged eyebolts.
15.
Remove the bolt that holds clip (18) for the fuel
bleed lines.
16.
Fasten a hoist to the timing gear cover.
17.
Remove the bolts and one nut that hold the timing
gear cover ( 17). Put identification on the bolts as
to their location for correct installation.
18.
Remove the bolt used to make an alignment of the
timing gears.
CAUTION: Do not cause damage to the crankshaft front seal
when the timing gear cover is removed and
installed.
19.
Pull timing gear cover (17) from the dowels on the
cylinder block to remove the water sleeves from
the cylinder heads. Remove the timing gear cover
and oil pump. The weight of the timing gear cover
and oil pump is 130 lb. (59 kg).
3-119