Install strap (25) on the torque converter
Remove tooling (A) from under- the torque
Install bolt (26), the washers and nut to hold
exhaust pipe assembly (27).
Connect wire (19) to the starting motor.
Put exhaust pipe assembly (27) in position and
install the bolts and nuts. (28) to h0old it to the
Connect oil pressure line (29) to the oil filter
Install the oil level gauge in the engine.
Fill the torque converter with clean hydraulic oil.
Lower the cab to its original position as follows:
Lower the cab with jack assembly (30).
Install the bolts an(d nuts that hold the left
rear fender to the cab.
Remove the pins that hold jack assembly
(30) in position and remove the jack
assembly from the tractor frame.