TM 5-3805-260-24
TORQUE CONVERTER
16.
Put clean oil on the ring on the shaft. Install
carrier ( 16) on the shaft as shown.
17.
Install the bearing in gear (17) with tool (B) and
an arbor press. Install the bearing until it is .32
in. (8.13 mm) below the machined surface (with
threaded holes) of the gear.
18.
Put wheel assembly (18) in position over gear
(17). Install the bolts and plates that hold the
unit together. Tighten the bolts to a torque of 20
1 lb. ft. (25 1 N. m).
19.
Install the wheel assembly over the carrier.
3-169