Fasten a hoist to converter housing (32) and put it in position
over the rotating housing.
Install six bolts (34) that hold the converter housing in position.
Tighten the bolts to a torque of 36 + 2 lb.ft. (46 + 3 N.m).
Install flange (33), the O-ring seal, the retainer and bolts that
hold the flange in position. Tighten the bolts that hold the
flange to a torque of 36 - 2 lb.ft. (46 + 3 N.m).
Install transmission oil pump (35). Install the four bolts that
hold it. Connect the tube assembly to the transmission oil
Install the steering and scraper hydraulic pump and the
elevator hydraulic pump. end by:
a) install torque converter