TRANSMISSION OIL PUMP
11. Install O-ring seals (16) on each side of case (17).
I2. Install case (17) on the spacer assembly.
13. Install the lip type seal in plate assembly (18)
with tooling (A). Make sure that the spring
loaded lip of the seal is toward the inside of the
plate assembly as shown.
14. Make a replacement of the pins in plate assembly
(18) if necessary.
15. Install plate assembly (18).
16. Install bolts (19) and tighten to a torque of 36 2
lb. ft. (46 3 Nm).
17. Install the key in the shaft.
18. Install gear (20) and tighten nut (21)
a) install transmission oil pump