REMOVE LOWER DRIVE
1. Remove bolts (I) and (2) and the nuts that hold
drive shaft (3) in position. Remove the drive
INSTALL LOWER DRIVE
1. Put drive shaft (1) in position on the machine.
Tighten the eight bolts and four nuts to a torque of
120 10 lb. ft. (160 14 Nm).
REMOVE UPPER DRIVE
a) remove transmission and transfer gears
1. Remove the four bolts that connect drive shaft (1)
to the torque converter and remove the drive
INSTALL UPPER DRIVE
1. Install drive shaft (1) and tighten bolts (2) to a
torque of 45 5 lb. ft. (60 7 Nm).
a) install transmission and transfer gears