TM 5-3805-260-24
STEERING CYLINDERS
DISASSEMBLE STEERING CYLINDERS
Tools Needed
A
B
C
1P510
Driver Group
1
1P1784
Hydraulic Cylinder
Repair Stand
1
5P3100
Pump Group
1
1P850
Torque Multiplier
1
1P8S1
Adapter
1
1P852
Adapter
1
55S6077
Socket
1
1. Remove bearings (1) from the cylinder (2)
and rod assembly (3) with tool group (A)
2. Place the cylinder on tooling (B)
Refer to page 3-305 for illustration.
3. Slowly extend the cylinder to drain the oil.
Install a support under the rod. Fasten a
strap around the rod to secure the support.
The support will prevent the rod from
dropping as the cylinder head is pulled away.
4. Unscrew head assembly (4) and pull cylinder
(2) away from rod and head assembly.
5. Remove nut (5) and washer (6) that retains
piston (7) to rod (2) with tooling (C).
6. Remove piston (7) from rod.
7. Remove two rings (8) and seal assembly (9)
from piston (7).
8. Remove seal (10) from piston.
9. Remove bushing (11).
10. Remove seal (12) and ring (13) from head
(3).
11. Remove plug (14) and unscrew gland assem-
bly (15) from head (3).
12. Remove packing (16) and washer (17) from
head (3).
13. Remove plug (18) and seal (19) from gland
assembly (15).
3-304