LOAD TRANSFER CYLINDER
REMOVE LOAD TRANSFER CYLINDER
Start the engine, and lower the load transfer
axle. Stop the engine.
the load transfer axle cylinder
the lugs on the axle. Start the
engine, retract the cylinders, and stop the
Disconnect two hoses; one from the dump
and lift valve, and one from the fitting under
the walkplate near the right front fender.
Attach jumper hose to fitting under walkway
and to dump and lift salve.
NOTE: Attach hoist to cylinder before removing
bolts (1), washers (2) and cap (3).
Remove four bolts (1), washers (2), cap (3)
and bearings. Remove cylinder.