BOWL AND EJECTOR CONTROL VALVE
Remove screw (14), spring (15) and poppet (13)
from the inside of the valve spool.
Remove snap ring (17) from valve spool (9) with
tool (B). Remove washers (18) and spring (16)
from the valve spool.
WARNING: Retainer is under tension from the
spring that is behind it.
Remove retainers(19) and (20) and the O-ring
seals. Check the condition of the O-ring seals. If
the seals have damage, use new parts for
Remove relief valve assembly (21) from the
body. Remove the washer and the seal from
inside the body.
Remove snap ring (28) with tool (A). Remove
sleeve (24) and the ball from housing (27). Turn
housing (27) counterclockwise off the valve
body (21) and remove piston (23), washer (26),
spring (22) and washers (shims) (25). Check the
condition of the O-ring seals. If the seals have
damage, use new parts for replacement.
NOTE: Keep the washers (shims) together for installation