TM 5-3805-260-24
EJECTOR FRONT GUIDE ROLLERS
2.
Install the lip type seal in the roller with tooling
(B). Install the seal until it makes contact with the
counterbore in the roller and with the lip of the
seal toward the inside of the roller.
3.
Turn the roller over. Install the expansion plug
with a press and tooling (C). Install the expansion
plug until it makes contact with the counterbore
n the roller.
4.
Install ring (2) on shaft (3).
5.
Fill roller with 5P960 Multipurpose Type
Grease. Put roller (1) on top of the bracket.
Install shaft (4) from the bottom of the bracket.
6.
Install bolt and nut (5) and adjust the roller
against rail as shown. Tighten the nut.
4-159