TM 5-2350-262-20-3
DELETED
HIGH/LOW LINKAGE WINCH ADJUSTMENT
NOTE
Ensure control lever is in NEUTRAL detent.
Control lever must move 0.10 in. (2.54 mm) in either direction without
engaging winch. Total NEUTRAL travel zone is 0.34 in. (8.64mm).
Remove cotter pin (1) and clevis pin (2) from clevis (3) and control lever (4). Discard
cotter pin (1).
Pull shift rod (5) out as far as possible. This is the end of travel in high-gear position.
Push shift rod (5) back in 1.220 in. (30.99 mm) to locate center of NEUTRAL position.
Adjustment can be made by turning clevis (3) clockwise for NEUTRAL position out;
counterclockwise for NEUTRAL position in.
Install clevis (3) on control lever (4) with clevis pin (2) and new cotter pin (1). Verify shift
rod (5) is within NEUTRAL travel limits.
Operate winch and check for proper operation. If winch does not function properly, notify
Direct Support maintenance.
Change 2
3-229