TM 5-3800-205-10-1
EXTERNAL AIR TRANSPORT BY CH-47 HELICOPTER - CONTINUED
0017 00
MACHINE DISASSEMBLY AND SECTIONALIZATION - CONTINUED
WARNING
Configuration change at cutting edge should NEVER be attempted without first securing the bowl by
blocking it so that it is firmly supported. Failure to follow this warning may cause injury to personnel.
13.
Attach two scraper bowl cutting edge wheels:
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during
procedure. Ensure any lifting device used is in good condition and of suitable lift capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury
to personnel.
a.
Start engine and raise bowl approximately 10 in. (25.4 cm) from the ground. Block bowl securely. Shut down
engine.
b.
With assistance and using a pry bar, position each cutting edge wheel centered on gusset underneath cutting
edge, with hooks engaged over top rear edge of cutting edge.
c.
Fully and evenly tighten two setscrews to secure each cutting edge wheel.
TOP REAR
2ND GUSSET
EDGE OF
HOOKS
IN FROM EDGE
CUTTING EDGE
390-1968
SETSCREWS
CUTTING
EDGE WHEEL
0017 00-15
