TM 5-3800-205-10-1
AIR TRANSPORT BY C-130 AIRCRAFT - CONTINUED
0018 00
CONFIGURE MACHINE FOR AIR TRANSPORT - CONTINUED
Table 2. Stowage Instructions for ISU-60 Container - Single-Door End.
COMPONENT
STOWAGE INSTRUCTIONS
Exhaust Stack and
1.
Place exhaust stack in left cutout of cushion pad, on left side of shelf. Lower end
Windshield Wiper Arm
of stack should be facing out.
Assembly
2.
Place windshield wiper arm assembly next to exhaust stack.
3.
Secure components with three straps.
Upper Handrail (with
1.
Place against right-side wall of container.
Side Mirror)
2.
Secure with one strap.
ROPS/FOPS
WARNING
ROPS/FOPS weighs 447 lb (203 kg). Use extreme caution when lifting and do
NOT allow to swing free.
CAUTION
Use caution not to damage windshield when handling ROPS/FOPS.
1.
Using a suitable three-point lifting device, lift ROPS/FOPS into position over tray,
with front of ROPS/FOPS to the right.
2.
Lower ROPS/FOPS onto four studs, one at each corner of tray.
3.
Secure ROPS/FOPS with two straps.
Toolbox
1.
Place toolbox on front edge of tray.
2.
Secure with three straps.
3.
Slide tray all the way in.
4.
Secure tray with two pins through tray and container floor.
Ramps
1.
Position each ramp against right wall of container.
2.
Secure each ramp with strap.
CAUTION
Check to ensure all components are securely fastened prior to closing and
securing door. Failure to do so may result in damage to equipment.
30.
Load ISU-60 container onto ramp of aircraft. Secure container with tiedowns in accordance with shipping data plate on
container.
RETURN MACHINE TO OPERATIONAL CONFIGURATION
NOTE
Whenever hydraulic hose quick disconnects needs to be connected, operate control levers though all posi-
tions (WP 0004 00) to relieve any dropped hydraulic pressure in hoses. This will facilitate connection of
hoses.
1.
Remove tiedowns and unload ISU-60 container from aircraft. Place container in staging area where machine will be
assembled.
2.
Remove blocking, shoring, and tiedowns from machine.
0018 00-35
