TM 5-3800-205-10-1
AIR TRANSPORT BY C-130 AIRCRAFT - CONTINUED
0018 00
RETURN MACHINE TO OPERATIONAL CONFIGURATION - CONTINUED
WARNING
Configuration change at cutting edge should NEVER be attempted without first securing the bowl by block-
ing it so that it is firmly supported. Failure to follow this warning may cause injury to personnel.
17.
Remove cutting edge wheels and set aside for stowage in ISU-60 container:
a.
Start engine and raise scraper bowl until approximately 10 in. (25.4 cm) from the ground. Block cutting edge
securely.
b.
Loosen two setscrews. With assistance and using a pry bar, remove each cutting edge wheel.
c.
Remove blocks, lower bowl, and shut down engine.
SETSCREWS
CUTTING EDGE
WHEEL
WARNING
If operating machine without ROPS/FOPS, drive with extreme caution, at low idle, and in 1st gear or reverse
ONLY. Machine has no rollover/falling object protection without ROPS/FOPS. Failure to follow this warn-
ing may cause injury or death to personnel or damage to equipment.
18.
NOTE: Machine is now drivable. However, until ROPS/FOPS is installed, it should be operated only with extreme cau-
tion, at low idle and in 1st gear or reverse ONLY. As required, move machine to a new location to complete machine
assembly.
19.
Return elevator to work configuration:
WARNING
Scraper floor and floor rollers are in motion when ejector is in motion. Stand clear of scraper bowl to avoid
injury to personnel.
a.
Start engine and raise elevator by moving ejector forward until elevator shafts are free of hangers.
0018 00-48
