TM 5-3800-205-23-1
ELECTRICAL GENERAL MAINTENANCE INSTRUCTIONS - CONTINUED
0033 00
CONNECTOR REPAIR
NOTE
Perform the following steps for each wire of connector.
Tag wires to aid in installation.
1.
Using pin removal tool, position tool over pin (1) and push inward to retract two barbs of pin.
2.
Remove wire (3) with pin (1) attached, from rear of connector (2).
3.
If defective, remove pin (1) from wire (3) by cutting through wire just behind pin.
3
2
1
390-1191
NOTE
Perform steps 4 through 6 only if pin was removed.
4.
Using wire stripping tool, strip insulation of wire (3) to expose proper length of metal strands (6).
5.
Using crimping tool, securely crimp tabs (5) of pin (1) over metal strands (6) of wire (3).
NOTE
The other two tabs of pin may need to be crimped slightly in order to enter connector.
6.
Using crimping tool, crimp tabs (4) at rear of pin (1) over insulation of wire (3).
4
3
5
1
6
390-1192
7.
Push pin (1) into rear of connector (2) until fully seated.
0033 00-3
