TM 5-3800-205-23-1
SERVICE BRAKE AIR SUPPLY BLOCK SOLENOID VALVE REPLACEMENT- CONTINUED
0066 00
REMOVAL
NOTE
Service brake air supply block solenoid is located below cab and above rear crossmember.
1.
Disconnect solenoid valve leads (1) from harness connector (2).
2.
Disconnect hose (3) from tee (10).
3.
Disconnect hose (5) from adapter (6) on valve (7).
4.
Disconnect hose (11) from tee (10).
5.
Remove two screws (8) and washers (9) from valve clamp (4).
6.
Remove valve (7) from crossmember (12).
7.
Remove tee (10) and two adapters (6) from valve (7).
8.
Inspect two adapters (6) and tee (10) for damage. Replace adapters and tee if damaged. Remove antiseizing tape from
threads of adapters and tee, if adapters and tee are not damaged.
4
3
2
1
5
6
7
6
8,9
10
11
INSTALLATION
1.
Apply antiseizing tape to threads of two adapters (6) and tee (10) and install adapters in valve (7).
2.
Install tee (10) on lower adapter (6).
3.
Install valve (7) on crossmember (12) with valve clamp (4), two screws (8) and washers (9).
4.
Connect hose (11) to tee (10).
5.
Connect hose (5) to other adapter (6).
6.
Connect hose (3) to tee (10).
7.
Connect solenoid valve leads (1) to harness connector (2).
Install rear guard plate (WP 0100 00).
8.
END OF WORK PACKAGE
0066 00-2
